Why use Crystal Serum Light Gtechniq?
Crystal Serum Light is the professional version of the famous Crystal Serum Ultra approved by Gtechniq.
It provides 80% Serum Ultra's professional performance, but if not used properly, it can be mechanically polished.
When it comes to adding shine, resisting holograms, pollutants and dirt, Gtechniq Crystal Serum Ultra and Serum Light are the ultimate products for paint protection.
Simple steps to help you get the best results.
To use Crystal Serum Light (CSL), please make sure your vehicle is indoors and can stay indoors for 12 hours after application.
Do not use it under direct sunlight.
Use the product only at temperatures between 5 and 25 degrees Celsius.
Shake well and wear gloves.
Before applying, wash and decontaminate the paint thoroughly.
If necessary, polish the paint, with a polisher or manually to remove imperfections.
The sprayed panels are wiped with a Gtechniq MF1 microfiber cloth, and each panel is wiped in small sections.
Impregnang the tampon with 3 complete CSL measurements of the pipette, then squeeze the liquid into the pads for even saturation.
Close the lid of the bottle and set it aside - do not put the bottle in your hand as this will promote premature hardening.
Apply overlaid over an area of about 50 cm by 50 cm.
Use MF1 wipes to remove residue immediately - you may need to wipe the same area several times, but avoid applying too much force.
We recommend using two cloths at a time.
Be sure to rotate the cloth while wiping it to prevent the CSL in the cloth from hardening.
Use a bright, diffuse light source to check the remnants of residues on the surface.
If you have hardened residue, you need to polish the area and reapply CSL.
After finishing, put the MF1 cloth in the water, wash and dry as soon as possible.
Wait about 2 hours after applying CSL to apply the ultra-durable hydrophobic EXO coating or C2 liquid crystal.
Keep in a cool, dry place.
Use within three months after opening
