Reference: 075040
Brand: Indasa
Reference: 075040
Brand: Indasa
Reference: RF751500
Brand: Indasa
Reference: 3M50413
Brand: 3M France - Marine Auto
Reference: FE180
Brand: Indasa
Reference: FE2500
Brand: Indasa
ABEL DEMOULAGE WAX 34D - 350 GR
(to be changed in the "Reinsurance" module)
(to be changed in the "Reinsurance" module)
(to be changed in the "Reinsurance" module)
Deflated compression heat-hardening, polyepidede and polyesters
up to a temperature of 135 degrees Celsius.
Use
Used by hand and allows for a very nice surface condition of the moulded parts.
Features
Cire 34 D is made from high-melting amide wax and contains silicone.
Aspect............................ Waxy
Color........................... Light yellow
Density........................... 0.8
Flash point................... 48oC / Flammable product
HOW TO USE IT
After preparing the mould with the 7890 F paste and glossing with LUSTRAVIT:
Spread out in a thin layer and continue the CIRE DE DEMOULAGE 34 D, following:
Place a little wax (wool or cotton) in a permeable cloth, tie the cloth into a ball, pressing lightly. Pass this ball over the mold so that the wax filters through the cloth, let it dry until a whitish veil appears and shine by hand without pressing. Repeat this three times to obtain a high-power separator film and a bright mirror. Mold.
Make a new application of CIRE 34 D whenever necessary,
Using a brush, coat the mold with a thin, continuous layer of CIRE 34 D. Mould immediately
Packaging
000622: 350g box - 000722: 980g box
Faced with the multiplicity of types and qualities of polyurethanes and laques and varnishes, more or less adapted to the techniques of composite fingerprinting on wood moulds or polyurethane varnish, we advise discourage the use of our waxes on moulds or shapes coated with these laques or varnishes.
However, if this technique is necessary, we strongly recommend that a preliminary orientation test be carried out on the lashy or polyurethane varnish applied to the media used.
This test says "styrene" is as follows:
Pour a drop of styrene into the stand to be tested in 4 or 5 places.
Cover each drop of a watch glass (to avoid evaporation)
Check progress after 12 hours, 24 hours and 48 hours or more if necessary.
Check the following points in comparison with the surface not in contact with styrene. :
Shine / Cloquage / Alteration of the hue
Hairs record or varnish may be considered unsuitable for intended use if they present defects in tarnish, blistering or skin change at points in contact with styrene.
Reviews subject to control
Based on 3
reviews
parfaite pour mon usage
très bon produit
bon produit
Reference: 002612
Brand: Abel
Reference: 000619
Brand: Abel
Reference: 7890
Brand: Abel
Reference: 005002
Brand: Abel
Reference: 013802
Brand: Abel