Mini Polishing Kit 3M Perfect-It 2 x 250 ml + 1x 250 gr

3M Fast Cut Plus Extreme 51818 Perfect-It Polishing Liquid is a highly abrasive liquid that can be used for polishing automotive and nautical paints to remove scratches generated during paint sanding steps.

It can also be used to remove oxidation marks, scratches and defects left by equipment from automatic cleaning stations, etc. on paints.
It is easy to wipe and lasts longer than the older generation of green cap 50417 and 51052 Fast Cut Plus.

Improved processing characteristics
• Reduce product usage by up to 30%
• Very easy to wipe
• Long working time
• Good finish
• Colourless, allowing identification of remaining sanding scratches before proceeding to the next step
• Few splashes
• Can be used with or without water

Bottle of 250 gr

This polishing liquid is to be applied with green polishing foam Ø 150 mm

The 80349 extra fine polishing liquid has been developed especially for the new anti-scratch varnishes, to give both great cutting power and an ultra-gloss finish.

This product can also be used on standard varnishes.

Used after the Trizact 50077 Polishing Liquid, it allows to restore very quickly an exceptional shine lasting over time.

It is recommended to use the 80349 with an electric or pneumatic polisher, set to a medium speed, equipped with a honeycomb orange foam Perfect-it 60107. The use of an orbital machine with very high eccentricity is an option that avoids possible holograms on very sensitive shades.

Key Features

⇒ Great cutting power

⇒ Easy wiping

⇒ Extra-fine finish and exceptional gloss

⇒ Little projection

⇒ Packaged in 250 ml cans with new yellow anti-lock cap for easy recognition

⇒ Ideal for completing a polishing operation with Trizact 3M 50077 polishing liquid

Method of application

1. Shake the can of polishing liquid well before use.

2. Apply a small amount of extrafine polishing liquid to 3M 50488 foam or directly to the surface. On larger areas, apply enough product to cover a 50cm x 50cm square.

3. Spread the product evenly using the foam before starting the machine to avoid splashing

4. Start the machine (average speed) and maintain a light pressure avoiding staying in one place so as not to cause heating of the varnish.

5. Polish until the liquid begins to dry, then reduce the pressure applied to the machine by slightly increasing the rotational speed.

6. Clean the worked surface with a microfiber cloth.

7. Repeat the operation on the rest of the panel of the area to be polished.

8. At the end of the process, the surface can be protected with the ultimate protective liquid – red cap – Perfect-it 09377.

9. Clean the foam(s) with water and let dry for later reuse

Ultrafine Perfect-It-III Ultrafina SE Liquid

Perfect-it IIITM Ultrafina SE 50383 is an ultra-fine finishing product designed to eliminate holograms and halos that may be present after polishing operations.

• Eliminates holograms and halos without the need for an orbital machine

• Apply with blue honeycomb foam and rotating polisher

• Provides optimal shine on the most delicate shades

• Easy wiping

This polishing liquid is to be applied with Blue Honeycomb Foam Ø 150 mm.