ABEL DEMOULAGE WAX 54D - 350G

DEMOULE HEATABLES, POLYEXIDES AND POLYESTERS UP TO A TEMPERATURE OF 170OC AND PRESSURE OF UP TO 100KG/CM2

Use

Used by hand and provides an effective waxy surface for several removals. It reduces the fouling of the mould and gives the unmoulded pieces a particularly deep gloss.

Features

54D wax is made from high-melting synthetic waxes and contains silicones

Aspect Hard wax

Color Pale green

Smell Low

Density 0,8

Flash point 40oC - Flammable product -

HOW TO USE IT

Polyester or polyepoxide laminates

After preparing the mould with the 7890 F paste and glossing with the LUSTRAVIT:

Spread in a thin layer and continue the 54D wax, following the following:

Place a little wax (wool or cotton) in a permeable cloth, tie the cloth into a ball, pressing lightly. Pass this ball over the mold so that the wax filters through the cloth, let it dry until a whitish veil appears and shine by hand without pressing.

Repeat this three times to obtain a high-power separator film and a bright mirror. Mold.

Make a new wax application whenever necessary.

Heat-cutting heatables up to 170oC.

Using a soft cloth well impregnated with wax, coat the mold with a thin, continuous layer. Mold immediately.

Given the severity of the stresses imposed (temperature and pressure), we recommend applying wax after each cast

Packaging

 Box of 0.350 Kg

Warning

Faced with the multiplicity of types and qualities of polyurethanes and laques and varnishes, more or less adapted to the techniques of composite fingerprinting on wood moulds or polyurethane varnish, we advise discourage the use of our waxes on moulds or shapes coated with these laques or varnishes.

However, if this technique is necessary, we strongly recommend that a preliminary orientation test be carried out on the lashy or polyurethane varnish applied to the media used.

This test called "styrene" is the following :

Pour a drop of styrene into the stand to be tested in 4 or 5 places.

Cover each drop of a watch glass (to avoid evaporation)

Check progress after 12 hours, 24 hours and 48 hours or more if necessary.

Check the following points in comparison with the surface not in contact with styrene. :

Shine / Cloquage / Alteration of the hue

Case of a lasca : With a white paper towel (sopalin), absorb the styrene drops and observe if the styrene has been colored by migrating the pigment.

Conclusion

Hairs record or varnish may be considered unsuitable for intended use if they present defects in tarnish, blistering or skin change at points in contact with styrene.